Saturday, February 11, 2017

January/February bars going out...

Ok, so originally I was only going to update this blog with new fabrication tutorial info, but it seems like I continue to do the same stuff over and over that has already been covered.  So, here's a quick post just to see if anyone is still out there...

Spent the better part of the last two weeks knocking out January/February bar orders and crafting up some tasty titanium cranks...

Much like welding a frame, the bars have a systematic welding process to keep them aligned and flat, starting with the linear ends of each miter



The bars are the only titanium item I single pass weld, as the additional heat of a two pass process becomes a bit more problematic with alignment.  To ensure complete penetration, a higher energy setting is used with a brief pulse to drive the arc deep into the substrate and feather out a bit wider than normal...




These titanium cranks are ran through the blast cabinet so that it will provide a mechanical surface for the ceramic to adhere to...



Colored and ready for action 3 hours later...


Thanks for tuning in,

Rody

No comments: